Carlson Curve commands?

[Stephen Rhodes]

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

[Nava Ran]

Construct IP,TP and CP and then:
Draw>Arc>Start,Center,End

"Stephen Rhodes" <stephen.rhodes@fyfe.com.au> wrote in message
news:cliue7$qrn$1@update.carlsonsw.com...

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

[Cad Dept]

We're talking SurvCADD XML R2 right? (too many newsgroup just want to
make sure I'm answering in the correct one)
try using curvecalc at the command line or using the pulldowns in COGO,
Design,Curves,Curve Calc..

this sounds like it should do all that you want

Stephen Rhodes wrote:

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance

[Stephen Rhodes]

Thanks Cad Dept - that's exactly it.
The command "2 Tangents, Tangent Length" - is what I didn't see before.
Regards...SR

"Cad Dept" wrote in message ...

We're talking SurvCADD XML R2 right? (too many newsgroup just want to
make sure I'm answering in the correct one)
try using curvecalc at the command line or using the pulldowns in COGO,
Design,Curves,Curve Calc..

this sounds like it should do all that you want

Stephen Rhodes wrote:

Welcome

Are there any Carlson commands that will calculate an arc (or TP, CP, IP
points) if I only have a two lines and an tangent distance?
What if for some strange reason I only have a two lines and an arc
length -
is there a command to make an arc?

The AutoCAD fillet command only works with a radius.

Thanks in advance