Offset Both Ways 3D Polyline

[RHPatten]

I am trying to set up the field to finish, for my company, that was recently purchased Carlson Civil suit.

The problem

I am setting up the Offset both ways (OFB) special code. When we run this on a 3D polyline, located on Real-Z, both lines are drawn to the right.
In every other scenario it works as expected. We did change our code to (OB), but the problem happens with OFB, and OB.

Any Help would be appreciated.

Thanks,

[Jason]

My programmers have found and fixed the problem and a patch will be in the next update. Sorry for the inconvenience.

[ColC]

There several odd combinations this creates. If the the original line is a 3D line then only the right side is offset and if it is a 2D both are plotted.

[RHPatten]

Actually the 3d line does offset both lines; it is just putting both on the right, (on top of one another).