I cannot get remote elevation to work. I can select an existing point or enter an R.L. it takes the measurements , I get a report showing everything OK then when I accept I get an error saying "Invalid Data Error". I have checked all the settings I can find there are no Remote Elevations settings I can find.
When starting my Traverse I have a point to occupy and if I select a new point number to use as my backsight(no Coordinates at this stage) . I enter a Backsight Azimuth into the screen. When I proceed I am told there is no coordinate for by backsight do I wish to exit or continue. I continue , I set angle and read. The measurements are recorded on the screen OK with backsight now set and a measured distance appearing on the screen. When I go to exit the backsight screen it hangs up and I have to reboot the Surveyor+.
I cannot believe that these problems still exist after waiting almost twelve months for this upgrade. Am I Robinson Crusoe on these problems?