Symbols

[Floyd Ward]

Using Survey 2006. I just created my own survey symbols, that I was use to
using in my previous cadd software. I placed them in a catagory that I
created called "Survey Symbols". I used the 'block' command to make them a
unit. Now, when I try to insert a symbol into my drawing with one of my
created symbols, I get a message in the command line that says "Block
IPFCONC references itself
*Invalid*" I does not insert my symbol into the drawing. What am I missing
here?


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[Kris]

I think you have to explode the block in the files its trying to block a
block which does not work so well in cad... also be sure to purge the
drawings of your symbols. Hope this helps.

-Kris

Floyd Ward wrote:

Using Survey 2006. I just created my own survey symbols, that I was use to
using in my previous cadd software. I placed them in a catagory that I
created called "Survey Symbols". I used the 'block' command to make them a
unit. Now, when I try to insert a symbol into my drawing with one of my
created symbols, I get a message in the command line that says "Block
IPFCONC references itself
*Invalid*" I does not insert my symbol into the drawing. What am I missing
here?


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[Floyd Ward]

Thanks Kris, that was the advice I was looking for. Your knowledge did the
trick.

Floyd

Kris wrote:

I think you have to explode the block in the files its trying to block
a
block which does not work so well in cad... also be sure to purge the
drawings of your symbols. Hope this helps.

-Kris

Floyd Ward wrote:
Using Survey 2006. I just created my own survey symbols, that I was
use to
using in my previous cadd software. I placed them in a catagory
that I
created called "Survey Symbols". I used the 'block'
command to make them a
unit. Now, when I try to insert a symbol into my drawing with one
of my
created symbols, I get a message in the command line that says
"Block
IPFCONC references itself
*Invalid*" I does not insert my symbol into the drawing. What
am I missing
here?


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##