Symbols In wrong PLace

[kfernandes]

I have creat symbols put them in my library and have made the center of my
symbol 0,0,0. Now how come when i do field to finish the symbol still
does not show up over the node. Any suggestions this is driving me crazy!


Thanks
Keith


##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

[R.K. McSwain]

kfernandes said the following on 4/25/2006 3:15 PM:

I have creat symbols put them in my library and have made the center of my
symbol 0,0,0. Now how come when i do field to finish the symbol still
does not show up over the node. Any suggestions this is driving me crazy!

Open each drawing, make sure the symbol geometry is relative to 0,0,0 as
desired -and- make sure INSBASE is set to 0,0,0 -and- make sure UCS = World.

--
R.K. McSwain
http://rkmcswain.blogspot.com

[GibEngSurv]

Keith,
Check the Symbol Pts. box in the FTF of the codes in question to make sure
the inserts art set to 0,0



kfernandes wrote:

I have creat symbols put them in my library and have made the center of
my
symbol 0,0,0. Now how come when i do field to finish the symbol still
does not show up over the node. Any suggestions this is driving me
crazy!

Thanks
Keith

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##

##-----------------------------------------------##
Article posted with MyNewsGroups
http://mynewsgroups.sourceforge.net
Share your knowledge in... carlson.carlson-survey
##-----------------------------------------------##