by Dent Cermak » Fri Dec 02, 2011 8:12 pm
Still there. Either go to the draw tab and select "line" or type "line" on the command line. The prompt should then be "Pick point or point number". Just type in the point number that you need anf repeat until you are through. (The same will work for polylines.)
For multiple points or batches, go under POINTS, DRAW/ LOCATE POINTS and click on the "Draw by Range" option. Here you can draw 1-100 or 1, 5, 7, 19, 100 , or whatever.
BUT, Field to Finish is much better and faster.