TrueCAD disk replacement

Create a replacement TrueCAD 2.50o disk set 

This procedure allows you to create a replacement disk set for TrueCAD version 2.50o.  This download should only be used by people who have already purchased TrueCAD version 2.  This program will not install on Windows Vista.

You will need three (3) blank 3 1/2" floppy disks to make a complete set.  You will need to name each disk as follows:

1.  Open Windows Explorer

2.  Insert a blank disk into the A: drive

3.  In Windows Explorer, right-click on the A: drive

4.  On the menu that appears, left-click Properties

5.  In the Label field, type TRUECAD1 and click OK

6.  Repeat the procedure with the other two disks, naming them TRUECAD2 and TRUECAD3

Left-click on each of the following three files.  When the File Download window appears, left-click on the Open button.  Insert a blank 3 1/2" disk into your A: drive.  The TRUECAD1 disk should be used for Disk 1, etc. When the WinZip Self Extracting window appears, click the Browse button and set the Unzip to Folder location as A:.  Click the Unzip button to create the disk.  When the files have finished expanding to the disk, remove the disk and label it with the appropriate number. 

To Install:  When the set has been completely copied, insert disk number 1, click Start, select Run, type A:Setup.exe and press <enter> to begin the setup program.

►  Disk 1          ►  Disk 2          ►  Disk 3 

© 2008 by Carlson Software, Inc.   Last modified November 18, 2008