Collector Connector (CC11)
Points Missing or Wrong
If Collector Connector transfers a file and your COGO program or data collector does not recognize some or all of the points that were transferred, there are a number of things to check to help determine why this happened.
1. Make sure that you entered the correct point number. If other points in your file have been transferred properly, you may just have mis-typed the point number.
2. Make sure that the point is actually in the file that was transferred.
3. Make sure that you transferred the correct file.
4. Make sure that you don’t have two different copies of the data file and you transferred an earlier one that doesn't contain the point you're trying to use.
5. Verify that you have selected the correct COGO File Type and that the format of your data file matches the format that Collector Connector uses for the selected file type. If none of the points in your file transferred properly, then the COGO File Type selected is either wrong, or Collector Connector uses a format which is different than the format of your data file. You can verify this by comparing your file to the format listed in the on-line help under the topic COGO File Formats.
© 2008 by Carlson Software, Inc. Last modified November 18, 2008
|